How Can UxHw® Improve Your Inspection Decisions?
A factory judges a part by measuring it and comparing the reading with a limit. Every measurement is a little wrong. The instrument does not say by how much. So the factory pads the limit for safety. Pad too far and good parts are scrapped, too little and defective ones reach the customer. The camera here reads 0.44 °C out on average and 5.35 °C at its worst pixel, past the ±3 °C its datasheet promises. Carry that error into the decision and three times fewer parts are judged wrongly. Enter your volume and what each mistake costs.
Units Inspected Per DayParts passing the inspection station a day.
40,000
Reject Rate TodayRejects per ten thousand inspected. The published precision figure says roughly half of these were never defects.25
Cost of Scrapping a Good PartMaterial plus the value added before the station. The starting figure is typical of the line you picked rather than a measurement of your plant, so replace it with your own.
Cost of Shipping a Bad PartWarranty, recall exposure, or the customer relationship. The starting figure is typical of the line you picked rather than a measurement of your plant. Its ratio to the scrap cost, rather than either figure by itself, decides the net position.
Acceptance ThresholdThe published work reports all three. Every one of them raises precision and lowers sensitivity. The 80th gives up the least sensitivity.
Override the speedup
This calculator's figures rest on one measured multiple, cited
with its baseline under the result. If you have measured your own, on your own workload, enter it
here and the arithmetic follows it. Nothing leaves the page. The citation under the figures still
reports what Signaloid measured, a banner above the result says the numbers are yours, and the
exported card and the quote mail both record the substitution. Clear the field to go back.
There is no single multiple to override here. This
calculator's figures rest on several separately measured quantities rather than on one speedup.
Each is cited with its own baseline under the result. Overriding one of them alone would give
a figure that follows from no measurement, so the field the other calculators carry is absent.
Speedup, ×
Signaloid Cloud Compute Engine
Turnkey. Signaloid supplies the compute, so it replaces this workload’s cloud bill rather than adding to it.
Turnkey. Signaloid supplies the compute, so it replaces this workload’s cloud bill rather than adding to it.
UxHw AWS Marketplace AMI
Runs on your own AWS, so the reservations and negotiated rates you already hold still apply.
Runs on your own AWS, so the reservations and negotiated rates you already hold still apply.
Enterprise On-Premises
For a workload that cannot leave the building.
For a workload that cannot leave the building.
Benefits